Network Card User Manual

RiverMaster Administrator’s Guide 55
Chapter 3 Routing
Configuring an ANG-3000/7000
Setting Routing Protocol Parameters
To access RIP and OSPF parameters for the ANG, perform the following
steps:
1 Open the Configuration pullout.
2 In the list of Aurorean devices, expand the tree list under Servers
(click the + symbol).
3 Expand the tree list under the name of your ANG.
4 Click on Routing to display the routing parameter tab pages.
5 Click on the Protocols tab to display protocol parameters for RIP and
OSPF.
6 Do one of the following:
– To set RIP parameters, choose RIP from the Routing Protocols
menu and click Properties; refer to the next section “Setting RIP
Properties” for additional instructions.
– To set OSPF parameters, choose OSPF from the Routing Protocols
menu and click Properties; refer to “Setting OSPF Properties” on
page 57 for additional instructions.
Setting RIP Properties
To configure RIP properties for the ANG, perform the following steps:
1 Perform the steps in the previous section to access RIP properties.
The RIP Configuration window should appear as shown in Figure 31.