Network Card User Manual

Table of Contents
iv RiverMaster Administrator’s Guide
Chapter 3 – Configuring an ANG-3000/7000
Before You Begin ...................................................................................................................26
Allocating IP/IPX Addresses to Remote Clients.......................................................27
Virtual Subnets for Site-to-Site and Remote Access Tunnel Servers.............. 30
Intelligent Client Routing .............................................................................................31
NAT Server......................................................................................................................33
Site-to-Site Tunnels ........................................................................................................34
AutoLink Recovery........................................................................................................35
General Aurorean Network Gateway Settings.................................................................37
Viewing Aurorean Alternate Address Information.........................................................42
Tunnel Protocols.................................................................................................................... 43
Virtual Subnetting................................................................................................................. 50
IP Subnetting ..................................................................................................................50
IPX Virtual Networks....................................................................................................52
Routing ...................................................................................................................................54
Setting Routing Protocol Parameters..........................................................................55
Setting RIP Properties........................................................................................... 55
Setting OSPF Properties........................................................................................ 57
Routing Interfaces.......................................................................................................... 59
Adding or Removing a Routing Protocol for an Interface............................... 60
Configuring RIP for the Interface........................................................................ 62
Configuring OSPF on an Interface...................................................................... 64
Creating Static Routes........................................................................................... 65
Adding a Remote Server......................................................................................................68
Changing Server and Tunnel Properties.....................................................................71