Network Card User Manual

228 RiverMaster Administrator’s Guide
Configuring Virtual Subnets Appendix B
ANG-3000/7000 Preconfiguration Stored on a Floppy Disk
Configuring Virtual Subnets
This optional section describes how to create virtual subnets that serve as IP
address pools for allocation to remote clients when they connect.
NOTE
Virtual subnets are configured for terminating ANGs only. If you are
configuring an initiating ANG, skip to “Configuring Routing Protocols”
on page 230.
Figure 127 Subnet Configuration Window
To set up virtual subnets of IP addresses to allocate to remote users, continue
floppy disk configuration with the following steps.