Switch Configuration Guide

IP Configuration Command Set
Configuring Load Sharing Network Address Translation (LSNAT)
12-72 Matrix NSA Series Configuration Guide
• (Optional) Allow specific clients direct access
to a real server without using LSNAT.
allow accessservers (Section 12.2.8.19)
Configure global direct access:
• (Optional) Allow all clients to directly access all
services provided by real servers EXCEPT FOR
those services configured to be accessed
through a configured virtual server. (See
“Configuring Direct Access to Real Servers” on
page 12-69 for more information.)
ip slb allowaccess_all (Section 12.2.8.20)
Display or clear server load balancing connections and statistics:
• (Optional) Display server load balancing
connections and statistics.
show ip slb conns (Section 12.2.8.21)
show ip slb stats (Section 12.2.8.22)
• (Optional) Display SLB active sticky
persistence connections.
show ip slb sticky (Section 12.2.8.23)
• (Optional) Clear server load balancing
connections or statistics.
clear ip slb (Section 12.2.8.24)
Display and set chassis-based LSNAT limits:
(Optional) From the switch CLI, display and set
chassis-based LSNAT address translation limits.
NOTE: These commands must be
executed from the switch CLI.
show router limits (Section 12.2.8.25)
set router limits (Section 12.2.8.26)
clear router limits (Section 12.2.8.27)
Table 12-8 LSNAT Configuration Task List and Commands (Continued)
Task Use these commands...