Switch Configuration Guide
Startup and General Configuration Summary
Process Overview: CLI Startup and General Configuration
Matrix NSA Series Configuration Guide 2-11
This example shows how to set the WebView TCP port to 100.
2.1.5 Process Overview: CLI Startup and General Configuration
Use the following steps as a guide to the startup and general configuration process:
1. Starting and navigating the Command Line Interface (CLI) (Section 2.1.6)
2. Configuring the Line Editor (Section 2.1.7)
3. Setting user accounts and passwords (Section 2.2.1)
4. Enabling or disabling of the management authentication notification MIB (Section 2.2.2)
5. Setting basic device properties (Section 2.2.3)
6. Activating licensed features (Section 2.2.4)
7. Downloading a new firmware image (Section 2.2.5)
8. Reviewing and selecting the boot firmware image (Section 2.2.6)
9. Starting and configuring Telnet (Section 2.2.7)
10.Managing image and configuration files (Section 2.2.8)
11.Enabling or disabling the MTU discovery protocol (Section 2.2.9)
12.Pausing, clearing and closing the CLI (Section 2.2.10)
13.Resetting the device (Section 2.2.11)
14.Gathering Technical Support Information (Section 2.2.12)
15.Preparing the device for router mode (Section 2.3)
Matrix(rw)->set webview port 100