Switch Configuration Guide
Discovery Protocols Command Set
Link Layer Discovery Protocol and LLDP-MED
3-48 Matrix NSA Series Configuration Guide
3.2.4.15 set lldp port med-trap
Use this command to enable or disable sending an LLDP-MED notification when a change in the
topology has been sensed on the port (that is, a remote endpoint device has been attached or
removed from the port).
set lldp port med-trap {enable | disable} port-string
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example enables transmitting LLDP-MED traps on ports ge.1.1 through ge.1.6.
enable Enable transmitting LLDP-MED traps on the specified
ports.
disable Disable transmitting LLDP-MED traps on the specified
ports.
port-string Specifies the port or range of ports to be affected.
Matrix(rw)->set lldp port med-trap enable ge.1.1-6