Switch Configuration Guide

Preparing the Device for Router Mode
Reviewing and Configuring Routing
Matrix NSA Series Configuration Guide 2-139
• Configure VLAN 1 on IP address 182.127.63.1 255.255.255.0 as the routing interface for that
module.
Figure 2-8 Enabling the Switch for Routing
2.3.2 Reviewing and Configuring Routing
Purpose
To review and configure routing .
Commands
The commands used to review and configure routing are listed below and described in the
associated sections as shown.
• show router (Section 2.3.2.1)
• set router (Section 2.3.2.2)
• clear router (Section 2.3.2.3)
• router (Section 2.3.2.4)
Matrix(rw)->set router 1
Matrix(rw)->router 1
Matrix>Router1>enable
Matrix>Router1#configure terminal
Enter configuration commands:
Matrix>Router1(config)#interface vlan 1
Matrix>Router1(config-if(Vlan 1))#ip address 182.127.63.1 255.255.255.0
Matrix>Router1(config-if(Vlan 1))#no shutdown