Switch Configuration Guide

General Configuration Command Set
Gathering Technical Support Information
Matrix NSA Series Configuration Guide 2-135
2.2.12.1 show support
Use this command to display output for technical support-related commands.
show support [filename]
Syntax Description
Command Defaults
The following commands are executed:
show version (Section 2.2.3.25)
show system hardware (Section 2.2.3.8)
show vlan (Section 7.3.1.1)
show vlan static (Section 7.3.1.1)
show logging all (Section 11.2.1.1)
show snmp counters (Section 5.3.1.2)
show port status (Section 4.3.2.2)
show spantree status (Section 6.2.1.1)
show spantree blockedports (Section 6.2.2.9)
show ip address (Section 2.2.3.1)
show ip route (Section 11.2.5.6)
show netstat (Section 11.2.2.4)
show arp (Section 11.2.5.1)
show system utilization (Section 2.2.3.9)
show config (Section 2.2.8.3)
Command Type
Switch command.
Command Mode
Read-Only.
filename (Optional) Filename (slotN/name) to save output.