- Cabletron Fast Network 10 USER GUIDE

Chapter 4: Monitoring and Managing Your FN10
Page 4-14 Fast Network 10 User Guide
4.3.3 Displaying Manufacturing Information
The ident command identifies FN10 manufacturing information,
including the part number and any power-up test codes and diagnostic
data. To display the manufacturing information, at the LCM prompt:
1. Type
ident
LCM displays the following type of information:
4.4 MANAGING THE FN10
Managing the FN10 consists of:
• Disabling and enabling Ethernet ports
• Changing a subnet mask
• Changing a community name
• Setting the baud rate of your terminal connection
• Setting a reboot time
You can use the Local Console Manager (LCM), any of the Cabletron
Systems NMSs, or a standard SNMP-based NMS to manage the FN10.
Refer to Section 4.1.
Part Number:
Power-up test codes:
Diagnostic data:
00000000 ff006000
501-3000-002
00000000 00000000 00000000 00000000
00000000 00000000 fffffffc fffffffc
X70002e4-0006891
Up-Link Module Part Number: 123-4567-891 X1234567-1234567