- Cabletron Fast Network 10 USER GUIDE

Chapter 4: Monitoring and Managing Your FN10
Page 4-12 Fast Network 10 User Guide
To display all MAC addresses, at the LCM prompt:
1. Type
addresses display any
LCM responds with a list of all MAC addresses, their associated ports,
the type, age, and number of frames from and to that address.
If you do not specify
any, only the learned static and other addresses are
displayed.
To display a specific address, at the LCM prompt:
1. Type
addresses display <MAC-ADDRESS>
For example, if you typed, addresses display 02:04:06:03:2a:43,
LCM would display the following information:
You can display a range of addresses by using a net mask. This is helpful
when determining the status associated with stations containing the same
make of Ethernet network interface cards. At the LCM prompt:
1. Type addresses display <MAC-ADDRESS> <NET-MASK>
For example, to see all addresses that begin with 02:04:06, you would
enter:
addresses display 02:04:06:00:00:00 ff:ff:ff:00:00:00
Address Type Port
Age(secs)
Frames-From Frames-To
08:00:20:02:3a:44
00:40:27:03:b7:21
Learned
Static
3
**
26
5
1
17110
0
195
Enter <CR> to continue, Ctrl-C to exit:
Address Type Port
Age(secs)
Frames-From Frames-To
02:04:06:03:2a:43 Learned 5
21 1181
73