- Enterasys Gigabit and Fast Ethernet Switches Hardware Installation Guide
Table Of Contents
- Enterasys® SecureStack™ B2 Gigabit and Fast Ethernet Switches Hardware Installation Guide
- Notice
- Regulatory Compliance Information
- Federal Communications Commission (FCC) Notice
- Clase A. Aviso de ITE
- Klasse A ITE Anmerkung
- Seguridad del Producto
- Produktsicherheit
- Electromagnetic Compatibility (EMC)
- Compatibilidad Electromágnetica (EMC)
- Elektro- magnetische Kompatibilität ( EMC )
- VCCI Notice
- BSMI EMC Statement - Taiwan
- Safety Information Class 1 Laser Transceivers
- Enterasys Networks, Inc. Firmware License Agreement
- Regulatory Compliance Information
- Notice
- Contents
- About This Guide
- Introduction
- Network Requirements
- Hardware Installation
- Considerations Prior to Installation
- Required Tools
- Unpacking the Switch
- Installing Optional Mini-GBICs
- Installing the Switch on a Flat Surface
- Rack Mounting the Switch
- Connecting High-Speed Stacking Cables
- Configuring Switches in a Stack
- Connecting AC and RPS-SYS Power
- Connecting to Console Port for Local Management
- Connecting to the Network
- Completing the Installation
- Troubleshooting
- Specifications
- Index
Connecting to the Network
3-24 Hardware Installation
Figure 3-14 Four-Wire Crossover Cable RJ45 Pinouts for 10/100BASE-TX
Figure 3-15 Four-Wire Straight-Through Cable RJ45 Pinouts for 10/100BASE-TX
1 RJ45 switch port 3 RJ45-to-RJ45 crossover cable
2 Other device port 4 RX+/RX- and TX+/TX-connections
These connections must share a common color pair.
1 RJ45 switch port 3 RJ45-to-RJ45 straight-through cable
2 Other device port 4 RX+/RX- and TX+/TX-connections
These connections must share a common color pair.
TX+
TX
RX+
RX 2
1
3
6
TX+
TX
2
1
3
6
RX+
RX
ÀÁ
Â
Ã
TX+
TX
RX+
RX 2
1
3
6
TX+
TX
2
1
3
6
RX+
RX
ÀÁ
Â
Ã