- Enterasys Gigabit and Fast Ethernet Switches Hardware Installation Guide
Table Of Contents
- Enterasys® SecureStack™ B2 Gigabit and Fast Ethernet Switches Hardware Installation Guide
- Notice
- Regulatory Compliance Information
- Federal Communications Commission (FCC) Notice
- Clase A. Aviso de ITE
- Klasse A ITE Anmerkung
- Seguridad del Producto
- Produktsicherheit
- Electromagnetic Compatibility (EMC)
- Compatibilidad Electromágnetica (EMC)
- Elektro- magnetische Kompatibilität ( EMC )
- VCCI Notice
- BSMI EMC Statement - Taiwan
- Safety Information Class 1 Laser Transceivers
- Enterasys Networks, Inc. Firmware License Agreement
- Regulatory Compliance Information
- Notice
- Contents
- About This Guide
- Introduction
- Network Requirements
- Hardware Installation
- Considerations Prior to Installation
- Required Tools
- Unpacking the Switch
- Installing Optional Mini-GBICs
- Installing the Switch on a Flat Surface
- Rack Mounting the Switch
- Connecting High-Speed Stacking Cables
- Configuring Switches in a Stack
- Connecting AC and RPS-SYS Power
- Connecting to Console Port for Local Management
- Connecting to the Network
- Completing the Installation
- Troubleshooting
- Specifications
- Index
SecureStack B2 Installation Guide xv
About This Guide
Thisguideprovidesanoverview,installationandtroubleshootinginstructions,and
specificationsfortheEnterasys
®
SecureStackB2G124‐24,B2G124‐48,andB2H124‐48
stackableEthernetswitches.
ForinformationabouttheCommandLineInterface(CLI)setofcommandsusedto
configureandmanagetheswitches,refertotheEnterasys Networks
®
SecureStackB2
ConfigurationGuide.
Who Should Use This Guide
Thisguideisintendedforanetworkadministratorresponsibleforinstallingandsetting
upthestackablesw itches.
Note: In this guide, the following terms are used:
• Switch refers to all three switches (B2G124-24, B2G124-48, and B2H124-48)unless
otherwise noted.
• MGBIC (Mini-Gigabit Interface Card) refers to optional small form pluggable (SFP)
interface modules that plug into the fixed front panel MGBIC slots.
Important Notice
Depending on the firmware version used in the B2G124-24, B2G124-48, and B2H124-48 switches,
some features described in this document may not be supported. Refer to the Release Notes
shipped with the switch to determine which features are supported.
Electrical Hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de
instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und
qualifiziertes Personal vorgenommen werden.