User's Manual

Hardware Installation
2-4
4. Connect the Ethernet Cable – The access point can be
wired to a 10/100 Mbps Ethernet network through a device
such as a hub or a switch. Connect your network to the RJ-45
port on the back panel with category 3, 4, or 5 UTP Ethernet
cable. When the access point and the connected device are
powered on, the Ethernet Link LED should light indicating a
valid network connection.
Note: The RJ-45 port on the access point uses an MDI pin
configuration, so you must use straight-through cable for
network connections to hubs or switches that only have
MDI-X ports, and crossover cable for network connections to
PCs, servers or other end nodes that only have MDI ports.
However, if the device to which you are connecting supports
auto-MDI/MDI-X operation, you can use either
straight-through or crossover cable.
5. Connect the Power Cord – Connect the power adapter to
the access point, and the power cord to an AC power outlet.
Otherwise, the access point can derive its operating power
directly from the RJ-45 port when connected to a device that
provides IEEE 802.3af compliant Power over Ethernet (PoE).
Note: If the access point is connected to both a PoE source
device and an AC power source, PoE will be disabled.
Warning:Use ONLY the power adapter supplied with this access
point. Otherwise, the product may be damaged.
Peligro: Use SOLAMENTE la fuente de alimentación que se
incluye con el punto de acceso. De lo contrario, el
producto podría dañarse.
Achtung:Verwenden Sie AUSSCHLIESSLICH das im Lieferumfang
enthaltene Netzteil für diesen Access Point. Anderenfalls
besteht die Gefahr, dass das Produkt beschädigt wird.