User's Manual

Introduction

1-6

Security Slot

The access point includes a Kensington security slot on the rear

panel. You can prevent unauthorized removal of the access point

by wrapping the Kensington security cable (not provided) around

an unmovable object, inserting the lock into the slot, and turning

the key.

Console Port

The console port is not used on the RBT-1002.

Ethernet Port

The access point has one 10BASE-T/100BASE-TX RJ-45 port

that can be attached directly to 10BASE-T/100BASE-TX LAN

segments. These segments must conform to the IEEE 802.3 or

802.3u specifications.

This port uses an MDI (i.e., internal straight-through) pin

configuration. You can therefore use straight-through twisted-pair

cable to connect this port to most network interconnection

devices such as a switch or router that provide MDI-X ports.

11a and 11b/g

(Wireless Link/

Activity)

Solid green A client is associated with the radio, or

the radio is in Sweep/Sentry mode.

Slow blink

green

(2 sec on/off)

Radio is unable to transmit. This state

can indicate inability to send a beacon

or radio failure.

Fast blink

green

Associated client is sending or

receiving traffic.

Unlit Indicates one of the following:

• The radio is disabled

• No clients are associated with the

radio and there is no traffic activity

LED Status Description