Network Router User's Manual

LEDs and Reset Button
Matrix X16-C Chassis Installation Guide 3-45
Figure 3-40 Fabric and Control Module LEDs and Reset Button
1 STATUS LEDs 3 RESET button 5 Link LED
2 ACTIVE/STANDBY LEDs 4 10/100/1000 LED
STATUS
ACTIVE/
STANDBY
RESET
ETHERNET
STATUS
ACTIVE/
STANDBY
1
2
1
2
3
4
5
Fabric Module Control Module
Table 3-3 Control and Fabric Module LED Definitions
CM & FM LED State LED Activity
Status Not powered Off
Diagnostics failed, module requires attention, or state before
initialization is complete
Red
LED blinks during initialization and diagnostics Blinking green
Diagnostics passed and software operational Green
Both chassis PROMs failed Amber
Active/Standby Not powered Off
Power on but not configured, hardware not initialized Red
Module is Active Green
Module is on Standby Amber
CM LEDs Only State LED Activity
Ethernet Status
(Link)
Link established Green
Link established and traffic flowing Blinking green
Unpowered, link or system failure, or administratively disabled Off
Ethernet Speed
(10/100/1000)
1000 Mbps Off
100 Mbps Green
10 Mbps Yellow