Network Router User's Manual

Powering Up the Matrix X16-C Chassis
Matrix X16-C Chassis Installation Guide 3-41
Powering Up the Matrix X16-C Chassis
TopoweruptheMatrixX16‐Cchassis,proceedasfollows:
1. Plugoneendofeachpowercord(includedwiththepowersupply)intotheACpowerinleton
thechassisbackpanelandtightenthecordlockbracketscrew,asshowninFigure 3‐35.
Figure 3-35 Connecting 20 Amp AC Power Cord to the Power Supply
2. Plugtheotherendofeachpowercordintoadedicated20 A/110 Vacor10 A/220 Vac 
receptacle.Ifyouareusingtheoptionaltwistlockpowercord,plugitinandturnuntilitlocks
securely.RefertoTable A‐6onpage A‐4formoreinformation.
3. Repeatsteps1and2forall
powercords.
4. EnsurethatthePowerLEDsoneachpowersupplyaregreen.
5. Ensurethatallfansinthefantrayunitareoperatingproperlywhenpowerisreceivedfrom
thepowersupplymodules(fantrayLEDwillbegreen).Formoreinformationonthepower
supplyLEDs,referto“Power
SupplyLEDs”onpage 3‐42.
Ifyouexperienceanyproblemswiththisinstallation,contactEnterasys Networksforassistance.
TheMatrixX16‐Cisnowreadytobeconfigured.
1 Power cord NOTE: Power cords shown are for North America.
2 AC inlet (AC1) and cord lock bracket Each power unit requires a 20 Amp circuit.
AC INLET 2
100-125V-20A
200-240V-8A
50/60Hz
AC INLET 1
100-125V-20A
200-240V-8A
50/60Hz
1
2