Network Router User's Manual

Attaching Cables, Installing Compact Flash Card and DIMM Upgrade Kit
3-30 Matrix X16-C Chassis Setup
5. ConnecttheX16‐C’s powercords.Referto“PoweringUptheMatrixX16‐CChassis”on
page 3‐41.
Figure 3-26 Connecting an IBM PC or Compatible
Connecting the CM COM Port to a VT Series Terminal
ToconnectaVTSeriesterminaltotheCM COMport(Figure 3‐27),useaUTPcablewithRJ45
connectorsandauser‐suppliedRJ45‐to‐DB25femaleadapter.Proceedasfollows:
1. ConnecttheRJ45connectoratoneendofthecabletotheCOMportontheCM.
2. Plugthe
RJ45connectorattheotherendofthecableintoauser‐suppliedRJ45‐to‐DB25female
adapter.
3. ConnecttheRJ45‐to‐DB25adaptertotheportlabeledCOMontheVTterminal.
4. TurnontheterminalandaccesstheSetupDirectory.Setthefollowingparameters:
5. ConnecttheX16‐C’s powercords.
Referto“PoweringUptheMatrixX16‐CChassis”on
page 3‐41.
1 UTP cable with RJ45 connectors 3 RJ45-to-DB9 PC adapter
2 RJ45 COM port 4 IBM PC or compatible device
STATUS
ACTIVE/
STANDBY
RESET
USB
ETHERNET
COM
2
34 1
Parameter Setting
Mode 7 Bit Control
Transmit Transmit=19,200
Bits Parity 8 Bits, No Parity
Stop Bit 1 Stop Bit