Network Router User's Manual

Installing and Removing Modules

Matrix X16-C Chassis Installation Guide 3-25

Installing and Removing FMs

1. LocatetheemptyFM1slotandpositionthemoduleintheguiderailattheleftoftheslot,as

showninFigure 3‐23.Gentlyinsertthemoduleuntilitengages with theconnectorsonthe

backplane,makingsuretheejectorhandlesareopen,asshowninFigure 3‐20.

Figure 3-23 Installing Fabric Module

2. Pushtheejectorhandlestowardthecenterofthemodule,asshownearlierinFigure 3‐20,

engagingthelipoftheslot,untilthemodulelocksintoplaceandisflushwithadjoining

coverplates.

3. Tightenthetwocaptivescrews.

1 Fabric Module slot 1 3 Guide rails 5 Captive screws (2)

2 Fabric Module 4 Ejector handles (2)

12 3 67845

FAN TRAY

STATUS

TX RX TX RX

STATUS

ACTIVE/

STANDBY

RESET

USB

ETHERNET

COM

FM1 FM2

9101112 13141516

STRAP

S/N: MAC ADD.

CM1 CM2

GROUND

STATUS

ACTIVE/

STANDBY