Network Router User's Manual

Unpacking the Matrix X16-C Chassis
3-2 Matrix X16-C Chassis Setup
Unpacking the Matrix X16-C Chassis
TheMatrixX16‐Cchassisispackedandshippedonaskid.Beforeunpackingthechassis,examine
theoutsidepackagingforobviousdamage.TounpacktheMatrixX16‐Cchassis,refertothe
followingfigureswhichillustratedisassemblyandincludenumbersthatcorrespondtothesteps
below.Proceedasfollows:
1. With
aboxcutter,cutthetwoshippingstrapsfasteningthecorrugatedboxtotheskid,as
showninFigure 3‐1.
2. Liftandremovetheshippingboxfromtheskid.
Figure 3-1 Disassembly Steps 1 and 2
3. Removeandsavetheracksupportbrackets,accessorypackage,documents,cable,andother
equipmentfromthetopofthestyrofoamcap,as
showninFigure 3‐2onpage 3‐3.Accessories
andoptionalequipmentinclude:
–ElectrostaticDischarge(ESD)wriststrap
– Installationdocumentation
–Screwassemblies
– Racksupportbrackets
–RJ45managementcable
4. Liftandremovethestyrofoamcapfromthetopofthechassis.Saveforreshipping,if
necessary.
Note: Unpack the Matrix X16-C chassis components only as needed. Leave the components in
their respective shipping cartons until you are ready to install that component. Save all shipping
materials in the event you must repack the chassis.
1 Shipping straps 2 Shipping box 3 Shipping skid
2
1
3