Network Router User's Manual

Matrix X16-C Chassis Installation Guide 3-1
3
Matrix X16-C Chassis Setup
Thischapterdescribesthefollowing:
Required Tools
Installationequipmentneededincludes:
•Boxcutter
• Phillipsscrewdri ver
•Flatbladescrewdriver
Aboxcutterisrequiredtocuttheshippingstraps.APhillipsscrewdriverisneededtoinstallthe
unitina19‐inch(48.26‐centimeter)equipmentrackandtoinstalltheoptionalCableManagement
Kit(referto“OptionalCableManagementKit”
onpage 3‐37formoreinformation).Aflatblade
screwdriverisusedtotightenandloosencaptivescrews.RefertoChapter 2forguidelinesthat
mustbefollowedtoinstalltheMatrixX16‐Cchassis.
For information about: Refer to page ...
Required Tools 3-1
Unpacking the Matrix X16-C Chassis 3-2
Setting Up the Matrix X16-C Chassis 3-5
Installing and Removing a Power Supply 3-13
Installing and Removing a Fan Tray 3-18
Installing and Removing Modules 3-20
Attaching Cables, Installing Compact Flash Card and DIMM Upgrade Kit 3-26
Installing the Optional Cable Management Kit 3-38
Powering Up the Matrix X16-C Chassis 3-41
LEDs and Reset Button 3-42
First-Time Quick Configuration 3-47
Electrical Hazard: Only qualified personnel should install or service this unit.
Riesgo Eléctrico: Solamente personal calificado debe realizar procedimientos de instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und qualifiziertes
Personal vorgenommen werden.