Switch Configuration Guide

no ip routing Performing a Basic Router Configuration
Enterasys Matrix DFE-Gold Series Configuration Guide 16-11
Performing a Basic Router Configuration
Using Router-Only Config Files
AlthoughtheEnterasysMatrixSeries’singleconfigurationinterfaceprovidesonesetof
commandstoperformbothswitchandrouterconfiguration,itisstillpossibletouserouter‐only
commandstoconfiguretherouter.Todoso,youneedtoaddrouterconfigwrapperstoyour
existingrouterconfigfiles,asshown
inFigure 16‐1.
Figure 16-1 Example of a Simple Enterasys Matrix Series Router Config File
begin router
enable
conf t
write file
exit
disable
exit
end router
Displaying or Writing the Current Config to a File
TheEnterasysMatrixSeries’singleconfigurationinterfaceallowsyouusetheshowconfig
commandtodisplayorwritethecurrentrouterconfigurationtoafile.Fordetails,referto“show
config”onpage 2‐85.
Configuring the Router
Youcanconfiguretherouterusingeitherofthefollowingmethods.
Using a downloaded file...
1. Downloadarouterconfigfiletothestandaloneorchassisusingthecopycommandas
describedin“copy”onpage 2‐86.
2. Runtheconfigurecommandusingthedownloadedconfigfileasdescribedin“configure”on
page 2‐86.
Creating and saving a custom file...
1. Enabletherouterasdescribedin“EnablingRouterConfigurationModes”onpage 2‐103and
configureitmanually.(ReferbacktoFigure 16‐1foranexampleofabasicconfigfile.)
2. Savetheconfigurationusingthewritefilecommandasdescribedin“write”onpage 16‐9.
Moving a Config File from Another Routing Module
Tocopyarouterconfigurationfromonemoduletoanother,proceedasfollows:
1. Fromtheroutingmoduleinwhichyouwishtocopyaconfigfile,performashowconfigon
thefileasdescribedin“showconfig”onpage 2‐85.