Switch Configuration Guide

Reviewing and Configuring Routing router
2-104 Startup and General Configuration
Router Configuration
Mode
Set IP protocol
parameters.
Type router and the
protocol name (and, for
OSPF, the instance ID)
from Global or Interface
Configuration mode.
Matrix>router
(config-router)#
Key Chain
Configuration Mode
Set protocol (RIP)
authentication key
parameters.
Type key chain and the
key chain name
from
Router (RIP)
Configuration mode.
Matrix>router
(config-keychain)#
Key Chain Key
Configuration Mode
Configure a specific
key within a RIP
authentication key
chain.
Type key
and the key-id
from Key Chain
Configuration Mode.
Matrix>router
(config-keychain-key)#
Route Map
Configuration Mode
Configure route maps
1-99.
Type route-map, an id-
number, and permit or
deny from Global
Configuration Mode.
Matrix>router
(config-route-map)#
Policy-Based
Routing
Configuration Mode
Configure policy-based
routing for route maps
100-199.
Type route-map, an id-
number, and permit or
deny from Global
Configuration Mode.
Matrix>router
(config-route-map-pbr)#
Server Load
Balancing (SLB)
Server Farm
Configuration Mode
Configure an LSNAT
server farm.
Type ip slb serverfarm
and the serverfarmname
from Global
Configuration Mode.
Matrix>router
(config-slb-sfarm)#
Server Load
Balancing (SLB)
Real Server
Configuration Mode
Configure an LSNAT
real server.
Type real and the real
server IP address from
SLB Server Farm
Configuration Mode.
Matrix>router
(config-slb-real)#
Server Load
Balancing (SLB)
Virtual Server
Configuration Mode
Configure an LSNAT
virtual server.
Type ip slb vserver and
the vserver-name from
Global Configuration
Mode.
Matrix>router
(config-slb-vserver)#
IP Local Pool
Configuration Mode
Configure a local
address pool as a
DHCP subnet
Type ip local pool and
the local pool name from
Global Configuration
Mode.
Matrix>router
(ip-local-pool)#
DHCP Pool
Configuration Mode
Configure a DHCP
server address pool.
Type ip dhcp pool and
the address pool name
from Global
Configuration Mode.
Matrix>router
(config-dhcp-pool)#
DHCP Class
Configuration Mode
Configure a DHCP
client class.
Type client-class and
the client class name
from DHCP Pool or Host
Configuration Mode.
Matrix>router
(config-dhcp-class)#
Table 2-9 Router CLI Configuration Modes (continued)
Use this mode... To... Access method... Resulting Prompt...