Switch Configuration Guide

Configuring Power over Ethernet (PoE) set inlinepower management
2-68 Startup and General Configuration
Example
ThisexampleshowshowtoresetthePoEthresholdto75onmodule1:
Matrix(rw)->clear inlinepower threshold 1
set inlinepower management
UsethiscommandtosetthePoEmanagementmodeonaspecifiedmodule.
Syntax
set inlinepower management {realtime | class} module-number
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtosetthePoEmanagementmodeto“class”onmodule1:
Matrix(rw)->set inlinepower management class 1
clear inlinepower management
UsethiscommandtoresetthePoEmanagementmodeonaspecifiedmodulebacktothedefault
settingof“realtime”.
Syntax
clear inlinepower management module-number
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
realtime Managespowerbasedontheactualpowerconsumptionoftheports.
class ManagespowerbasedontheIEEE802.3afdefinitionoftheclassupper
limit,exceptclasses0and4,forwhichtheactualpowerconsumptionis
used.
module‐number SpecifiesthemoduleonwhichtosetthePoE
managementmode.
module‐number SpecifiesthemoduleonwhichtoresetthePoEmanagementmode.