Switch Configuration Guide

Configuring Power over Ethernet (PoE) set inlinepower assigned
2-66 Startup and General Configuration
set inlinepower assigned
UsethiscommandtomanuallyassignPowerSourcingEquipment(PSE)powertoamoduleinthe
chassis.
Syntax
set inlinepower assigned power-value slot-number
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Usage
Ifthetotalpowerwattagevaluesetwiththiscommandisgreaterthatthemaximumpower
percentagespecifiedwiththesetinlinepoweravailablecommand(“setinlinepoweravailable”on
page 2‐63),awarningwilldisplay.Iftheuseroptstoexecutetheseparameters,aratioofassigned
powerwillbeapplied
toeachmodule.Refertotheshowinlinepoweroutput(“show
inlinepower”onpage 2‐61)forasamplewarningmessage.
Example
Thisexampleshowshowtoassign200wattsofpowertothemoduleinslot1:
Matrix(rw)->set inlinepower assigned 200 1
clear inlinepower assigned
Usethiscommandtoclearthepowervaluemanuallyassignedtooneormoremodules.
Syntax
clear inlinepower assigned [slot-number]
Parameters
Defaults
Ifslot‐numberisnotspecified,powervalueassignmentswillbeclearedfromallmodules.
Mode
Switchcommand,Read‐Write.
power‐value Specifiesapowervalueinwatts.
slot‐number Specifiesamoduleslotlocationforthepowerassignment.
slot‐number (Optional)Clearsthepowerassignmentfromaspecificmodule.