- Enterasys Switch Hardware Installation Guide

Gaining Access to Memory Modules

B-12 Mode Switch Settings and Option Installations

Figure B-8 Installing the DIMM

Installing the Network Expansion Module (NEM)

RefertoFigure B‐9andproceedasfollows:

1. PositiontheNEMsoitsfrontpanelisundertheedgeoftheDFE modulefrontpanel.

2. AlignthetwoNEMconnectorswiththemainboardconnectors.Thenpressstraight

downoverthetwoNEMconnectors,applyingpressureuntiltheyareproperly

seated.

1 DIMM 3 Connector arms

2 Connector fingers 4 Alignment notches (2)