- Enterasys Switch Hardware Installation Guide

Gaining Access to Memory Modules

Enterasys Matrix DFE-Gold Series PoE Module Hardware Installation Guide B-11

2. LocatetheDIMMconnectoronthemainPCboard.ReferbacktoFigure B‐2forthe

DIMMlocationontheDFEmodule.

3. PushtheconnectorarmsawayfromtheDIMM,asshowninFigure B‐7,and

simultaneouslylifttheDIMMenoughtoreleaseitfromtheconnectorfingers.

Figure B-7 Removing the Existing DIMM

4. Rotatethe

DIMMupwards,thenremoveitfromtheconnectorfingers.

Installing the DIMM

ToinstallaDIMM,refertoFigure B‐8andproceedasfollows:

1. InserttheDIMMdownbetweentheconnectorfingers.

2. PivottheDIMMdownwardsothetabsontheconnectorarmsalignwiththetwo

DIMMalignmentnotches.Withthetwoconnectorarmsspreadoutward,pushthe

DIMMdownbetweentheconnector

arms.Thenreleasethetwoconnectorarmsto

locktheDIMMintoplace.

3. Reinstallthesafetycover.Referto“ReinstallingtheSafetyCover”onpage B‐14for

instructions.

1 Connector arms 2 DIMM 3 Connector fingers

Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive

electronic equipment.

Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones

de seguridad para evitar descargas de electricidad estática.