- Enterasys Ethernet Switches Reference Manual

show port trap
4-20 Port Configuration
show port trap
UsethiscommandtodisplaywhethertheportisenabledforgeneratinganSNMPtrapmessageif
itslinkstatechanges.
Syntax
show port trap [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,thetrapstatusforallportswillbedisplayed.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtodisplaylinktrapstatusforge.3.1through4:
D2(su)->show port trap ge.3.1-4
Link traps enabled on port ge.3.1.
Link traps enabled on port ge.3.2.
Link traps enabled on port ge.3.3.
Link traps enabled on port ge.3.4.
set port trap
UsethiscommandtoenableofdisableportsforsendingSNMPtrapmessageswhentheirlink
statuschanges.
Syntax
set port trap port-string {enable | disable}
clear linkflap action 4-25
set linkflap threshold 4-26
set linkflap downtime 4-27
clear linkflap down 4-27
clear linkflap 4-28
For information about... Refer to page...
port‐string (Optional)Displayslinktrapstatusforspecificport(s).Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntaxUsed
intheCLI”onpage4‐1.