- Enterasys Ethernet Switches Reference Manual

clear port priority-queue
10-6 Port Priority and Rate Limiting Configuration
Usage
PrioritytotransmitqueuemappingonanindividualportbasiscanonlybeconfiguredonGigabit
Ethernetports(
ge.x.x).Whenyouusethesetportpriority‐queuecommandtoconfigureaFast
Ethernetport(
fe.x.x),themappingvaluesareappliedgloballytoallFastEthernetportsonthe
system.
Example
Thisexampleshowshowtosetpriority5framesreceivedonge.2.12totransmitonqueue0.
D2(su)->set port priority-queue ge.2.12 5 0
clear port priority-queue
Usethiscommandtoresetportpriorityqueuesettingsbacktodefaultsforoneormoreports.
Syntax
clear port priority-queue port-string
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoclearthepriorityqueuesettingsonge.2.12:
D2(su)->clear port priority-queue ge.2.12
Configuring Quality of Service (QoS)
Purpose
Eighttransmitqueuesareimplementedintheswitchhardwareforeachport.Thecommandsin
thissectionallowyoutosettheprioritymodeandweightforeachoftheavailablequeues(0
through7)foreachphysicalportontheswitch.Prioritymodeandweightcannotbeconfiguredon
LAGs,
onlyonthephysicalportsthatmakeuptheLAG.
Commands
port‐string Specifiestheportforwhichtoclearpriority‐to‐queuemappings.Fora
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 4‐1.
For information about... Refer to page...
show port txq 10-7