Computer Hardware User Manual

DIMM Replacement Procedure
PN 9033946 Page 3 of 5
DIMM Replacement Procedure
Although the following replacement procedure describes how to replace a DIMM in an angled
connector, the procedure also applies to DIMM replacement in a vertical connector.
Removing the Existing DIMM
Refer to Figure 1 and proceed as follows:
1. Push the connector arms
➀ away from the DIMM ➁ to release it from the connector ➂.
2. Remove the module from the connector
➂.
Figure 1 Removing the Existing DIMM
Installing the DIMM
To install the memory module, refer to Figure 2 and proceed as follows:
1. With the connector arms
➀ set in the open position, insert the DIMM ➁ between the
connector fingers
➂.
2. Push the memory module into the connector until the tabs on the two connector arms pull in
towards the DIMM alignment notches
➄.
Caution: Observe all antistatic precautions when handling sensitive electronic equipment.
➀
Connector arms
➁
DIMM
➂
Connector
Â
À
À
Á
Caution: Observe all antistatic precautions when handling sensitive electronic equipment.
Caution: The connectors on different DFE modules may have the keys inside the connector
reversed. To prevent damaging the DIMM and main pc board, make sure that key slots
➃ are
positioned to match those in the connectors. Otherwise, the DIMM and pc board will be damaged.