- Enterasys Gigabit Ethernet Switch Installation Guide

Installing the Switch on a Flat Surface
SecureStack C2 Installation Guide 3-5
ToremoveanXFPfroma portslot,referbacktoFigure 3‐1,andproceedasfollows:
1. Attachyourantistaticwriststrap(refertotheinstructionsinyourantistaticwrist
strappackage)beforeremovingtheXFP.
2. RemovethecableconnectedtotheXFP.
3. LocatetheXFPwirehandleandpulldownon
ittoreleasetheXFP.
4. GraspthesidesoftheXFPand pullitstraightoutoftheportslot.
IfstoringorshippinganXFP,whichhasafiber‐opticconnector,insertitsprotectivedust
covertoprotecttheendsofthefiber‐opticfibersfromdustorcontamination.
Installing the Switch on a Flat Surface
Wheninstallingtheswitchonaflatsurface,theinstallationoftherubberfeetis
recommendedtopreventtheswitch fromslidingonaflatsurface.Installingtherubber
feetisoptionalifyouareinstallingtheswitchinarack.Toinstalltherubberfeet,proceed
to“Installingthe
RubberFeet”instructionsbelow.Forinstructionstorackmountthe
switch,proceedto“RackMountingtheSwitch”onpage 3‐7.
Installing the Rubber Feet
Toinstalltherubberfeet,refertoFigure 3‐2andproceedasfollows:
1. Placetheswitchonitsbackonasturdyflatsurfacetogainaccesstothebottomofthe
chassis.
2. Removethefourrubberfeetfromtheirplasticbagintheshipping box.
3. Locatethefourmarkedlocationson
thebottomfourcornersofthechassis.