- Enterasys Standalone Switch Installation Guide

Memory Locations and Replacement Procedures

N Standalone Series Installation Guide B-5

DIMM Replacement Procedure

IftheDIMMisdefectiveandmustbereplaced,thefollowingsectionsexplainhowto

removeandinstalltheDIMM.Ifyouhavequestionsconcerningthereplacementofthe

DIMM,contactEnterasys Networks.

Removing the DIMM

ToremovetheexistingDIMM,proceedasfollows:

1. Followsteps1through3asinstructedon(pageB‐7).

2. LocatetheDIMMconnectoronthemotherboardasshowninFigure B‐2.

3. PushtheconnectorarmsawayfromtheDIMM,asshowninFigure B‐3,and

simultaneouslylifttheDIMMenough

toreleaseitfromtheconnectorfingers.

Figure B-3 Removing the Existing DIMM

4. RotatetheDRAMSIMMupwards,thenremoveitfromtheconnectorfingers.

1 Connector arms 2 DIMM 3 Connector fingers

3835_00_14