- Enterasys Standalone Switch Installation Guide

Using LANVIEW
N Standalone Series Installation Guide 4-3
CPU None Power off. Ensure chassis has adequate power.
Amber Blinking. Device in bootup process. None.
Solid. Testing. If the LED remains amber for several minutes,
contact technical support.
Green Blinking. Image starts running. None.
Solid. Functional. None.
Red Solid. Processor in reset. None.
Green
and
Amber
Blinking. Indicates that the 2G4072-52
is in the process of shutting down.
None. This state is activated when the RESET
button is pressed for less than 1 second to
start an orderly shutdown.
Amber
and off
Alternating (67% on, 33% off).
Indicates a shutdown is complete. The
indication will hold for 60 seconds then
automatically restart.
While in this state, you have 60 seconds
before the 2G4072-52 will reboot.
RX
(Receive)
None No link. No activity. Port enabled or
disabled.
None.
Green Solid. Link present, port enabled, no
traffic is being received by the interface.
None.
Amber Flashing. Link present, port enabled,
traffic is being received by the interface.
None.
Red Blinking. Indicates collisions.
(Supported on 10/100 ports only)
Contact technical support.
TX
(Transmit)
None Port enabled, but no activity. If you know the port should be active and is
not, contact technical support.
Green Flashing. Indicates data transmission
activity. Flashing frequency indicates
the data rate.
None.
Red Flashing. Fault or Error (collision). None, unless activity is high in which case
check for network configuration problems or a
defective device.
Table 4-1 LANVIEW LEDs (continued)
LED Color State Recommended Action