- Enterasys Standalone Switch Installation Guide

Using LANVIEW
4-2 Troubleshooting
Figure 4-1 LANVIEW LEDs
Table 4‐1describestheLEDindicationsandprovidesrecommendedactions.
1 Group Select button 2 Group LEDs 3 LANVIEW LEDs
NOTE: The terms used in Table 4-1 indicate:
Flashing - an LED is flashing randomly.
Blinking - an LED is flashing at a steady rate (approximately 50% on, 50% off).
Solid - a steady LED light. No pulsing.
Alternating - an LED is flashing in a steady rate other than 50% on, 50% off.
RESET
CONSOLE
CPU
PWR
GROUP
SELECT
GROUP 3
GROUP 2
GROUP 1
1
2
3
4
À ÂÁ
2
TX
RX
Table 4-1 LANVIEW LEDs
LED Color State Recommended Action
PWR Off Device not receiving power from power
supply.
Ensure the power cords are plugged in and
there is power at the source.
Contact technical support for help.
Green Functional. Power supply operating
normally.
None.
Amber Indicates loss of power supply
redundancy.
Ensure the power cords are plugged in and
power is available at the source.
Contact technical support for help.