- Enterasys Standalone Switch Installation Guide

Completing the Installation
N Standalone Series Installation Guide 3-19
2. Attheloginprompt,enteroneofthefollowingdefaultusernames:
– roforRead‐Onlyaccess,
– rwforRead‐Writeaccess,or
– adminforSuperUseraccess.(ThisaccesslevelallowsRead‐Writeaccesstoall
modifiableparameters,includinguseraccounts.)
3. PressEnter.
4. ThePasswordpromptdisplays.Leavethisstring
blankandpressEnter.Thedevice
informationandMatrixpromptdisplaysasshowninFigure 3‐15.
TheEnterasysMatrixNSA2G4072‐52isnowreadytobeconfigured.Forinformation
aboutsettingtheIPaddressandconfiguringTelnetsettingsforremoteaccesstoN
StandaloneSeriesmanagement,refer
toChapter3intheEnterasysMatrixNStandalone
SeriesConfigurationGuide.
TheCLIcommandsenableyoutoinitiallysetupandperformmoreinvolved
managementconfigurations.TheEnterasysMatrixNStandaloneSeriesConfigurationGuide
isavailableonlineat:
http://www.enterasys.com/support/manuals