- Enterasys Standalone Switch Installation Guide

Completing the Installation
3-18 Installation
Completing the Installation
AfterinstallingtheEnterasysMatrixNSA2G4072‐52andmakingtheconnectionstothe
network,accessthedevicemanagementstartupscreenfromyourPC,terminal,ormodem
connectionasdescribedinthefollowingsection.
Log-In Using a Console Port Connection
StarttheCommandLineInterface(CLI)fromthedevice’slocalconsoleportasfollows:
1. Connectaterminaltothelocalconsoleportasdescribedin“ConnectingtotheCOM
PortforLoca lManagement”onpage 3‐13.Thestartupscreen,Figure 3‐15,displays.
Modem Port Adapter Wiring and Signal Diagram
RJ45 DB25
Pin Conductor Pin Signal
1Blue2Transmit(TX)
2Orange8DataCarrierDetect(DCD)
4 Red 3 Receive
5 Green 7Ground(GRD)
6Yellow20DataTerminalReady (DTR)
8 Gray 22 RingIndicator
RJ45 Connector (Female)
Pins
81
Pins
DB25 Connector (Male)
131
2514
Note: This procedure applies only to initial log-in and to logging in to a device not yet
configured with administratively-supplied user and password settings.
By default, the Matrix N Standalone Series device is configured with three user login
accounts: ro for Read-Only access; rw for Read-Write access; and admin for super-user
access to all modifiable parameters. The default password is set to blank (carriage return).
For information on changing these default passwords, refer to Chapter 3 in the
Enterasys
Matrix N Standalone Series Configuration Guide.