Specifications

Battery Charging
1. Connect the AC adapter to the charger
pod. The LED status light will illuminate
green indicating ready for charge
2. Turn the transceiver off
3. Insert the battery pack into the charger
pod, either with or without the
transceiver attached. The LED status light
changes from green to RED & trickle
charge begins
4. A fully discharged battery pack will take
approximately 6 hours to charge,
depending on the remaining power
condition. When charge is complete, the
LED status light turns green.
Overcharging:
The battery pack has an over-current
protection circuit fitted. When charging a
completely discharged battery i.e. first charge,
ensure the battery is removed from the radio
and then re-attached (if fitted to radio when
charging). This will reset the protection
circuitry and ensure normal operation.
6
Battery Care / Information
This process will need to be repeated if the
battery is allowed to completely discharge in
the future. In normal use this is unlikely.
Battery Indicator
For your safety and con-
venience your
transceiver continually
monitors the battery pack and gives an
indication on the LCD:
• 3 Segments: 12 hours
• 2 Segments: 1 hour
• 1 Segment: 20 mins
Note: Only genuine Entel batteries should be
used. Customer satisfaction is assured as you
can not be supplied with sub standard,
potentially dangerous battery packs from 3rd
party manufacturers, ensuring it delivers the
expected capacity and endurance.
On HT series batteries a breathable
membrane is used. This is clearly marked on
the battery label. Piercing the membrane will
allow water ingress to the battery, & will
invalidate the warranty.
Optional Accessories
Attaching & Removing Accessories
To attach an accessory: Remove the accessory cover by unscrewing the
locking screw anti-clockwise (leave cover attached or store in a safe place).
Attach accessory plug to the socket. Carefully tighten the locking screw
clockwise until finger tight (do not tighten with a screwdriver etc).
To remove an accessory: Unscrew the locking screw of the accessory by
hand in an anti-clockwise direction (carefully use a coin or screwdriver if too
tight). Ensure you re-fit the accessory cover so as to protect the socket.
Common