User`s guide

3—Selecting and Finding Effects
2 ENSONIQ DP/Pro Reference Manual
Selecting Effects from the DP/Pro’s Front Panel
Effects are selected from the DP/Pro’s front panel by:
• pressing the Select Effect button.
Select
Tweak Tap
Page
Find
Previous Next
Effect
• turning the Value knob to browse through the effects in memory to locate the desired effect.
• pressing the Enter button to install the effect.
The Enter LED will flash when you’ve selected an effect to remind you that you haven’t yet
installed it. This provides an easy way to tell whether the effect that’s displayed is the effect
you’re hearing.
Tip: If you’ve selected an effect, but not yet installed it, you can press the Cancel button to
return the DP/Pro’s display to the currently installed effect.
Automatic Installation of Effects
The DP/Pro can be set so that it automatically installs effects as they’re selected. See “Automatic
Installation of Effects and Algorithms” in Chapter 2.
Selecting Effects Via MIDI
When the DP/Pro’s System/MIDI Accept MIDI Messages parameter is set to “Yes,” its effects can be
selected via MIDI by:
• sending Bank Select and Program Change messages to the DP/Pro on its system MIDI channel
(see Chapter 2) corresponding to the bank and memory location in which the desired effect
resides.
• pressing the Enter button to install the effect.
The Enter button’s LED will flash to remind you to install the effect.
Note: The DP/Pro will ignore MIDI Bank selects and Program Changes that select empty
memory locations.