User`s guide

2—System/MIDI Parameters
ENSONIQ DP/Pro Reference Manual 13
System/MIDI Parameter 41: (Song) Effect
Song=1 Name=Undefined Step=1
> Effect=None
i
Values: None; 0000* through 3005
Default: None
What this Parameter Does:
The Effect parameter allows you to assign any of the DP/Pro’s effects to the step currently selected
with the Step parameter.
Each effect is shown as a four-digit number. The first digit represents the bank in which the effect is
stored. The three remaining digits show the program number of each effect within the selected bank.
If System/MIDI parameter 76 is set to “Yes,” an asterisk following the effect’s bank and program
numbers shows that the memory location is currently empty. ” If parameter 76 is set to “No,” unused
locations will not be available for selection by this parameter.
D e signat ing R e al- Tim e Cont r olle r s
Every parameter in each of the DP/Pro’s algorithms can be manipulated in real time, allowing for the
creation of highly animated effect processing. The DP/Pro supports the use of a wide variety of
control mechanisms, ranging from the two virtual Tweak knobs, to foot switches, to all 121 MIDI
controllers.
The first step in setting up real-time control of the DP/Pro’s effects is to establish of suite of up to 16
control mechanisms that you’d like to have available for this purpose—these are referred to as DP
Cntlrs 1 through 16. You can use any of the 16 for real-time control of any algorithm parameter.
To learn more about real-time control of the DP/Pro’s effects, see Chapter 10.
System/MIDI Parameters 42 through 57: DP Cntlr 1 through DP Cntlr 16
DP Cntlr 1 =TwkKnob 1 DP
Cntlr 2 =TwkKnob 2
Values: Off This setting disables the selected DP Cntlr.
TwkKnob1 The selected DP Cntlr will use the first of the DP/Pro’s two virtual tweak knobs.
To utilize Tweak Knob 1 from the DP/Pro’s front panel, the Tweak LED must be
lit and the Knob 1 Name parameter must be showing when these conditions are
met, the Value knob operates as the displayed tweak knob. Tweak Knob 1 may be
used as a real time controller via MIDI at any time, regardless of the state of the
Tweak LED or the DP/Pro’s display (see “Using the Tweak Knobs with MIDI
Controllers” later in this chapter).
TwkKnob2 This serves a similar function as the “Twk Knob 1” setting, except that it enables
the use of the second of the DP/Pro’s two virtual tweak knobs; see above.
LFO 1 The selected DP Cntlr will use the first of two mod LFOs available in each DP/Pro
effect.
LFO 2 The selected DP Cntlr will use the second of two mod LFOs available in each
DP/Pro effect.