User`s guide

1—Introduction
ENSONIQ DP/Pro Reference Manual 11
though your DP/Pro battery should last for years, you may eventually need to have it replaced by an
authorized ENSONIQ Repair Station.
The DP/Pro will tell you when its battery needs replacing. It will flash the following when you power
up:
Warning! Main battery is
low. See manual.
This display will appear only briefly, and then allow you to proceed normally. Make sure that
everything in RAM that you’d like to keep—or any special system settings—have been safely stored
on an external MIDI storage device—as described in Chapter 2—and take the DP/Pro to an
authorized ENSONIQ Repair Station as soon as possible to have the battery replaced.
Reinitializing the DP/Pro
All computer-based devices—including the DP/Pro—occasionally experience signs of data
corruption. If your DP/Pro begins acting oddly, you can reinitialize its software to clear out any
problems lurking there.
Warning: Make sure you’ve saved any effects or system settings that you want to preserve to
an external MIDI device before reinitializing. Reinitializing erases the contents of the
DP/Pro’s user memory banks, and resets all System/MIDI parameters to their default values.
To Reinitialize the DP/Pro
1. Hold down the System/MIDI button.
2. While continuing to hold the System/MIDI button, press the Cancel button.
3. Let go of both buttons. The displays shows:
Press ENTER to Reinit. All data
will be lost!
4. Press the Enter button to reinitialize the DP/Pro.