User`s guide

10—Effect Modulation
6 ENSONIQ DP/Pro Reference Manual
Mod A/B Parameters 7, 16, 25, 34: (Absolute) Min (1), (Absolute) Min (2),
(Absolute) Min (3), (Absolute) Min (4)
Mod A/B Parameters 8, 17, 26, 33: (Absolute) Max (1), (Absolute) Max (2),
(Absolute) Max (3), (Absolute) Max (4)
The modulation setup being edited The minimum value that modulation can produce
m m
Dest1 Min=0.00oct
Max=0.65oct
i
The maximum value that modulation can produce
Values: destination parameter’s values
What these Parameters Do:
The (Absolute) Min (1), (Absolute) Min (2), (Absolute) Min (3), (Absolute) Min (4), (Absolute) Max (1),
(Absolute) Max (2), (Absolute) Max (3), (Absolute) Max (4) parameters allow you to set the highest
and lowest values to which the destination parameter can be set as a result of modulation.
Ge t t ing t o Know t he DP /P r o M odulat or s
Overview of the DP/Pro’s Virtual Tweak Knobs
Each DP/Pro effect provides for the use of two virtual controllers that allow you to manipulate effects
in real time from its front panel: Tweak Knob 1 and Tweak Knob 2. When either of these is active,
turning the Value knob turns the active virtual tweak knob. Once activated, each tweak knob
functions in the same way as any other modulator, and may be used for the modulation of any ESP
mixer or algorithm parameter. The tweak knobs are programmed to be real-time controllers using the
method described in “Selecting a Modulator” earlier in this chapter.
Tip: The ROM effects in the DP/Pro make extensive use of the tweak knobs.
Naming an Effect’s Tweak Knobs
Since each effect contains two of these virtual controllers, you can assign them names to help keep
track of the tasks you’ve programmed them to perform. The tweak knob names are programmed in
the same manner as any other Mod A or Mod B parameter and saved as part of the effect. You can
access the currently selected effect’s tweak knob name parameters from ESP-A or ESP-B.
Mod A/B Parameters 37-49: Knob 1 Name
Mod A/B Parameters 50-62: Knob 2 Name
Knob1 Name=Bloom Fractal
Knob2 Name=Swirl Factor
Values: characters, numbers, letter
What these Parameters Do: