User`s guide

8—Mixing

2 ENSONIQ DP/Pro Reference Manual

Editing Mixer Parameter Settings

The mixer parameters are edited by:

• pressing the Params A or B button repeatedly until “Mixer Params” appears on the top line of the

DP/Pro’s main display.

Routing

Algo B Params B Mod B Bypass B

Algo A Params A Mod A Bypass A

Edit

• pressing the Next or Previous Page buttons to select the parameter you’d like to edit.

• turning the Value knob to set the selected parameter to the desired value.

Tip: If you’d like to undo your most recent parameter edit, press the Cancel button. You can

also double-click the Cancel button to quickly reset any algorithm parameter to its default

setting.

Setting an ESP’s Input Level

The DP/Pro allows you to individually control the volume of the audio being sent into each ESP. The

adjustment is measured in decibels relative to the original signal level. Positive values increase the

input level; negative values decrease it.

Mixer Parameter 1: ANA Inp Level

ESP-A: Mixer Params ANA Inp

Level=+0.0dB

Values: -99.0dB through +6.0dB

Default: +0.0db

What this Parameter Does:

The ANA Inp Level parameter allows you to set the volume of analog audio being fed into each ESP.

Setting an ESP’s Stereo Input Balance

The DP/Pro allows you to alter the stereo imaging of the audio being sent into each ESP by adjusting

its left/right balance as it enters the ESP. The amount of panning shift is shown as a percentage of

change to the original balance, with arrows showing the direction of the shift.