Specifications

Part # 9310 0177 01 - B Model # MM-86
Vocal—Rock

Dual Delay
#87
0276
E
EF
02765 762765
EF

Large Room Rev
#51
~


This Quick-Start sends your voice through a short stereo delay effect and then on to a large room reverb.
1. Turn the DP/2 inputs and outputs knobs down all the way (counter-clockwise).
2. Plug your vocal’s effect send from your mixer into the DP/2’s rear-panel Input 1 jack.
3. Connect cables from the DP/2’s back-panel Output 1 and 2 jacks to two returns on your mixing console. If you’ve only
got one return available, connect a cable from Output 1.
4. While singing, turn the input 1 knob up until the red peak LED above it flashes occasionally.
5. Turn the outputs knob up until your mixer is receiving the proper level from the DP/2.
6. Press the {SYSTEM/MIDI} button. Press the {>} button until the large red number reads “46.” Use the data entry knob to
dial in “Set All 1U Pset Mixes To Wet=Yes.”
7. Press the {EDIT} button, {CONFIG}, and then{<} until the large red numbers read “00.”
8. Use the data entry knob to set the DP/2 to “1 Source Config.”
9. Press {>} once. Use the data entry knob to set the AB Input Select to “mono.”
10. Press {>} once. Set the AB Unit Routing to “serial.”
11. Press {>} until “(b)ypass (k)ill” is displayed, and the letter following “A=“ is flashing. Dial in the letter “k” (if “k” isn’t already
displayed). Press {>} again to do the same for Unit B.
12. Press the {A} button. If its red LED is flashing, press it again. Press {<} until the red numbers are flashing. Use the data
entry knob to dial in #87, Dual Delay—the “87” will start flashing.
13. Press {>} until “Left Input Delay Time=“ is displayed. Dial in “115.00 ms.”
14. Press {>} until “Left Input Delay Regen=21” is displayed and the “21” is flashing. Dial in “00.”
15. Press {>} until “Right Input Delay Time=“ is displayed. Dial in “143.00 ms.”
16. Press {>} until “Right Input Delay Regen=21” is displayed and the “21” is flashing. Dial in “00.”
17. Press {>} until “Dual Delay Cross Regen=“ is displayed and the “-47” is flashing. Dial in “00.”
18. Press the {B} button. If its red LED is flashing, press it again. Press {<} until the red numbers are flashing. Dial in #51,
Large Room Rev. In a moment, the “51” will begin to flash.
19. To save the set-up, press {CONFIG}. Press {WRITE}. Use the data entry knob to select a location in the DP/2’s
memory. Press {WRITE} again.
20. Name your set-up by using the {>} and {<} buttons to underline each character, and the data entry knob to dial in the
character you want. When you’re done, press {WRITE} again.
Tip: To customize either of the effects, press {EDIT}, the appropriate letter and {>} or {<} to select its
parameters; use the data entry knob to edit them. You can change the “Volume=“ parameter in an effect to adjust
how much of it you’ll hear. You can also press the {A} or {B} buttons to turn off either of the processors (its red
LED will flash). Press again to turn it back on (the red light will go out). Footswitches can accomplish the same
thing—see the “Using Foot Switches” Quick-Start for details.