Specifications

Part # 9310 0177 01 - B Model # MM-86
Vocal—Duet

Hall Reverb
#52
0276
E
EF
02765 762765
EF

Hall Reverb
#52


This Quick-Start provides two singer with their own reverbs. It employs the rich Hall Reverb effect, but you can dial in any
other reverb you’d like at Steps 12 and 13.
1. Turn the DP/2 inputs and outputs knobs down all the way (counter-clockwise).
2. Plug one vocal’s effect send from your mixer into the DP/2’s rear-panel Input 1 jack and the other’s into Input 2.
3. Connect cables from the DP/2’s back-panel Output 1 and 2 jacks to two returns on your mixing console. If you’ve only
got one return available, connect a cable from Output 1 only.
4. While the first vocalist sings, turn the input 1 knob clockwise until the red peak LED just above it is flashing occasionally.
Do the same with the second vocalist and input 2.
5. Turn the outputs knob up until your mixer is receiving the proper level from the DP/2.
6. Press the {SYSTEM/MIDI} button. Press the {>} button until the large red number reads “46.” Use the data entry knob to
dial in “Set All 1U Pset Mixes To Wet=Yes.”
7. Press the {EDIT} button, and then the {CONFIG} button.
8. Press the {<} button until parameter 00 is displayed in large red numbers.
9. Use the data entry knob to set the DP/2 to “2 Source Config.”
10. Press {>} once. Set the AB Output Select to “Mixed Stereo.”
11. Press {>} until “(b)ypass (k)ill” is displayed, and the letter following “A=“ is flashing. Dial in the letter “k” (if “k” isn’t already
displayed). Press {>} again to do the same for Unit B.
12. Press the {A} button. If its red LED is flashing, press it again. Press {<} until the red numbers are flashing. Use the data
entry knob to dial in #52, Hall Reverb—the “52” will start flashing.
13. Press the {B} button. If its red LED is flashing, press it again. Press {<} until the red numbers are flashing. Dial in #52,
Hall Reverb. In a moment, the “52” will begin to flash.
14. To save the set-up, press {CONFIG}. Press {WRITE}. Use the data entry knob to select a location in the DP/2’s
memory. Press {WRITE} again.
15. Name your set-up by using the {>} and {<} buttons to underline each character, and the data entry knob to dial in the
character you want. When you’re done, press {WRITE} again.
Tip: To customize either of the effects, press {EDIT}, the appropriate letter and {>} or {<} to select its
parameters; use the data entry knob to edit them. You can change the “Volume=“ parameter in an effect to adjust
how much of it you’ll hear. You can also press the {A} or {B} buttons to turn off either of the processors (its red
LED will flash). Press again to turn it back on (the red light will go out). Footswitches can accomplish the same
thing—see the “Using Foot Switches” Quick-Start for details.