Specifications

Part # 9310 0177 01 - B Model # MM-86
Solo Instrument—Rock

Dual Delay
#87
0276
E
EF
02765 762765
EF

Large Room Rev
#51
~


This Quick-Start is for solo reed and wind players performing rock.
1. Turn the DP/2 inputs and outputs knobs down all the way (counter-clockwise).
2. Connect your instrument’s effect send from your mixer to the DP/2’s rear-panel Input jack 1.
3. Connect cables from the DP/2’s back-panel Output 1 and 2 jacks to two inputs on your mixing console or stereo
amplifier. If you’ve only got one input available on your mixer (or amp), connect a cable from the DP/2’s Output 1 to that
input.
4. While playing your instrument, turn the input 1 knob clockwise until the red peak LED just above it is flashing
occasionally.
5. Turn the outputs knob up until your mixer (or amp) is receiving the proper level from the DP/2.
6. Press the {SYSTEM/MIDI} button. Press the {>} button until the large red number reads “46.” Use the data entry knob to
dial in “Set All 1U Pset Mixes To Wet=Yes.”
7. Press the {EDIT} button, and then the {CONFIG} button.
8. Press the {<} button until the large red numbers read “00.”
9. Use the data entry knob to set the DP/2 to “1 Source Config.”
10. Press {>} once. Use the data entry knob to set the AB Input Select to “mono.”
11. Press {>} once. Set the AB Unit Routing to “serial.”
12. Press {>} until “(b)ypass (k)ill” is displayed, and the letter following “A=“ is flashing. Dial in the letter “b” (if “b” isn’t already
displayed). Press {>} again to do the same for Unit B.
13. Press the {A} button. If its red LED is on, press it again. Press {<} until the red numbers are flashing. Use the data entry
knob to dial in #87, Dual Delay—the “87” will start flashing.
14. Press {>} until “Left Input delay” is displayed and “375” is flashing. Dial in a value of 70. Use the {>} button and the data
entry knob to set Left Input Delay Regen to 00, Right Input Delay to 98.00, Right input Delay Regen to 00 and Dual
Delay Cross Regen to 00.
15. Press the {B} button. If its red LED is on, press it again. Press {<} until the red numbers are flashing. Dial in #51, Large
Room Rev. In a moment, the “51” will begin to flash.
16. To save the set-up, press {CONFIG}. Press {WRITE}. Use the data entry knob to select a location in the DP/2’s
memory. Press {WRITE} again.
17. Name your set-up by using the {>} and {<} buttons to underline each character, and the data entry knob to dial in the
character you want. When you’re done, press {WRITE} again.
Tip: To customize either of the effects, press {EDIT}, the appropriate letter and {>} or {<} to select its
parameters; use the data entry knob to edit them. You can change the “Volume=“ parameter in an effect to adjust
how much of it you’ll hear. You can also press the {A} or {B} buttons to turn off either of the processors (its red
LED will flash). Press again to turn it back on (the red light will go out). Footswitches can accomplish the same
thing—see the “Using Foot Switches” Quick-Start for details.