Specifications

Part # 9310 0177 01 - B Model # MM-86
Singer/Guitarist

TunableSpeaker 2
#60.
0276
E
EF
02765 762765
EF

Large Plate Rev
#54


This Quick-Start is for singers who perform with a guitar which has a pick-up. It provides a clean and rich amp simulation for
your guitar and a reverb for your voice. MIDI One-Person bands who are using a mono PA system can use this set-up as well,
by plugging in their keyboard (or keyboard sub-mixer) into the front-panel input 1 jack.
1. Turn the DP/2 input and output knobs down all the way (counter-clockwise).
2. Plug your guitar cord into the DP/2’s front-panel input 1 jack.
3. Connect your vocal’s effect send from your mixer to Input jack 2.
4. Connect cables from the DP/2’s back-panel Output 1 and 2 jacks to the effect returns on your mixing console. If you’ve
only got one effect return on your mixer, use Output 1.
5. While playing your guitar, turn the input 1 knob clockwise until the red peak LED just above it is flashing occasionally.
6. While singing, turn up your vocal’s effect sends to a healthy level. Turn the DP/2’s input 2 and knob clockwise until the
red peak LEDs just above it is flashing occasionally.
7. Turn the DP/2 outputs knob up until your mixer is receiving the proper level from the DP/2.
8. Press the {EDIT} button, and then the {CONFIG} button.
9. Press the {<} button until parameter 00 is displayed in large red numbers.
10. Use the data entry knob to dial in “2 Source Config.”
11. Press {>} . Set the AB Output Select to “Mixed Stereo.”
12. Press {>} until “(b)ypass (k)ill” is displayed, and the letter following “A=“ is flashing. Dial in the letter “b.” Press {>} again
and dial in “k” for Unit B.
13. Press the {A} button. If its red LED is on, press it again. Press {<} until the red numbers are flashing. Dial in #60.,
TunableSpeaker 2. (This will be the second #60 you encounter, and will have a small dot to the right of the numeral.) In a
moment, the “60.” will start flashing.
14. Press the {B} button. If its red LED is flashing, press it again. Press {<} until the red numbers are flashing. Dial in #54,
Large Plate Rev—the “54” will begin to flash.
15. Press {>} twice and set Volume= to 50.
16. To save the set-up, press {CONFIG}. Press {WRITE}. Use the data entry knob to select a location in the DP/2’s
memory. Press {WRITE} again.
17. Name your set-up by using the {>} and {<} buttons to underline each character, and the data entry knob to dial in the
character you want. When you’re done, press {WRITE} again.
Tip: To customize either of the effects, press {EDIT}, the appropriate letter and {>} or {<} to select its
parameters; use the data entry knob to edit them. You can change the “Volume=“ parameter in an effect to adjust
how much of it you’ll hear. You can also press the {A} or {B} buttons to turn off either of the processors (its red
LED will go on). Press again to turn it back on (the red light will go out). Footswitches can accomplish the same
thing—see the “Using Foot Switches” Quick-Start for details.