Specifications

Part # 9310 0188 01 - A Model # MM-87
Mixing in Mono

Large Plate Rev
#54
0276
E
EF
02765 762765
EF

Dual Delay
#87


This Quick-Start describes how to set up the DP/2 as two separate effect devices, fed by two separate mono effect sends from
your mixing console. It provides a reverb and a delay effect, but you can just as easily dial in any effect that you like at Steps
11 and 12.
1. Connect your mixer’s two effect sends to the DP/2’s rear-panel Input 1 and 2 jacks.
2. Connect a cable from the DP/2’s back-panel Output 1 jack to an effect return or fader on your mixer. Don’t plug a cable
into the DP/2 Output 2 jack.
3. While sending signal through the two effect sends, turn the DP/2’s input knobs clockwise until the red peak LEDs just
above them are flashing occasionally.
4. Turn the outputs knob up until your mixer is receiving the proper level from the DP/2.
5. Press the {SYSTEM/MIDI} button. Press the{>} button until the large red number reads “46.” Use the data entry knob to
dial in “Set All 1U Pset Mixes To Wet=Yes.”
6. Press the {EDIT} button, and then the {CONFIG} button.
7. Press the {<} button until the large red numbers read “00.”
8. Use the data entry knob to set the DP/2 to “2 Source Config.”
9. Press {>} once. Set the AB Output Select to “Dual Mono.”
10. Press {>} until “(b)ypass (k)ill” is displayed, and the letter following “A=“ is flashing. Dial in the letter “k” (if “k” isn’t already
displayed). Press {>} again to do the same for Unit B.
11. Press the {A} button. If its red LED is flashing, press it again. Press {<} until the red numbers are flashing. Dial in #54,
Large Plate Rev—the “54” will start flashing.
12. Press the {B} button. If its red LED is flashing, press it again. Press {<} until the red numbers are flashing. Dial in #87,
Dual Delay. In a moment, the “87” will begin to flash.
13. To save the set-up, press {CONFIG}. Press {WRITE}. Use the data entry knob to select a location in the DP/2’s
memory. Press {WRITE} again.
14. Name your set-up by using the {>} and {<} buttons to underline each character, and the data entry knob to dial in the
character you want. When you’re done, press {WRITE} again.
Tip: To customize either of the effects, press {EDIT}, the appropriate letter and {>} or {<} to select its
parameters; use the data entry knob to edit them. You can change the “Volume=“ parameter in an effect to adjust
how much of it you’ll hear. You can also press the {A} or {B} buttons to turn off either of the processors (its red
LED will flash). Press again to turn it back on (the red light will go out). Footswitches can accomplish the same
thing—see the “Using Foot Switches” Quick-Start for details.