Specifications

Part # 9310 0177 01 - B Model # MM-86
KeyboardElectric Piano Panner
Flanger
#78
0276
E
EF
02765 762765
EF
EQ-Panner-DDL
#76.
~
This Quick-Start makes your keyboard swing back-and-forth in the stereo field like an old electric piano. It also provides a
flanging effect for an extra bit of swirl, lovely for ballads.
1. Turn the DP/2 inputs and outputs knobs down all the way (counter-clockwise).
2. Plug your keyboards output cable into the DP/2s front-panel input 1 jack. If your keyboard has stereo outputs, plug them
into the DP/2s rear-panel Input jacks 1 and 2.
3. Connect cables from the DP/2s back-panel Output 1 and 2 jacks to two inputs on your stereo guitar amplifier or mixing
console. If youre going into a single-input guitar amp or mixer, connect a cable from the DP/2s Output 1 to that input.
4. While playing your keyboard, turn the input 1 knob clockwise until the red peak LED just above it is flashing occasionally.
If your keyboards stereo, turn up input 2s knob as well.
5. Turn the outputs knob up until your amp (or mixer) is receiving the proper level from the DP/2.
6. Press the {EDIT} button, and then the {CONFIG} button.
7. Press the {<} button until the large red numbers read 00.
8. Use the data entry knob to set the DP/2 to 1 Source Config.
9. Press {>} once. Set the AB Input Select to mono, or if your keyboards stereo, to stereo.
10. Press {>} once. Set the AB Unit Routing to serial.
11. Press {>} until (b)ypass (k)ill is displayed, and the letter following A= is flashing. Dial in the letter b (if b isnt already
displayed). Press {>} again to do the same for Unit B.
12. Press the {A} button. If its red LED is on, press it again. Press {<} until the red numbers are flashing. Use the data entry
knob to dial in #78, Flangerthe 78 will start flashing.
13. Press the {B} button. If its red LED is on, press it again. Press {<} until the red numbers are flashing. Dial in #76., EQ-
Panner-DDL. (This will be the second #76 you encounter, and will have a small dot to the right of the numeral.) In a
moment, the 76. will begin to flash.
14. Use the {>} button and the data entry knob to set Panner Rate to 65 and Width to 99.
15. To save the set-up, press {CONFIG}. Press {WRITE}. Use the data entry knob to select a location in the DP/2s
memory. Press {WRITE} again.
16. Name your set-up by using the {>} and {<} buttons to underline each character, and the data entry knob to dial in the
character you want. When youre done, press {WRITE} again.
Tip: To customize either of the effects, press {EDIT}, the appropriate letter and {>} or {<} to select its
parameters; use the data entry knob to edit them. You can change the Volume= parameter in an effect to adjust
how much of it youll hear. You can also press the {A} or {B} buttons to turn off either of the processors (its red
LED will flash). Press again to turn it back on (the red light will go out). Footswitches can accomplish the same
thingsee the Using Foot Switches Quick-Start for details.