Specifications

Part # 9310 0177 01 - B Model # MM-86
Electric Guitar—Rock

Guitar Amp 4
#55.
0276
E
EF
02765 762765
EF

Large Room Rev
#51
~


This Quick-Start is designed for guitarists recording directly into a mixing console. It gets its big sound by sending your guitar
through a rock amplifier simulation and then into a large room reverb.
1. Turn the DP/2 inputs and outputs knobs down all the way (counter-clockwise).
2. Plug your guitar cord into the DP/2’s front-panel input 1 jack.
3. Connect cables from the DP/2’s back-panel Output 1 and 2 jacks to two inputs on your stereo guitar amplifier or mixing
console. If you’re going into a single-input guitar amp or mixer, connect a cable from the DP/2’s Output 1 to that input.
4. While playing your guitar, turn the input 1 knob clockwise until the red peak LED just above it is flashing occasionally.
5. Turn the outputs knob up until your amp (or mixer) is receiving the proper level from the DP/2. The output knobs should
be turned up by an equal amount.
6. Press the {EDIT} button, and then the {CONFIG} button.
7. Press the {<} button until parameter 00 is displayed in large red numbers.
8. Use the data entry knob to set the DP/2 to “1 Source Config.”
9. Press {>} once. Use the data entry knob to set the AB Input Select to “mono.”
10. Press {>} once. Set the AB Unit Routing to “serial.”
11. Press {>} until “(b)ypass (k)ill” is displayed, and the letter following “A=“ is flashing. Dial in the letter “b” (if “b” isn’t already
displayed). Press {>} again to do the same for Unit B.
12. Press the {A} button. If its red LED is on, press it again. Press {<} until the red numbers are flashing. Use the data entry
knob to dial in #55., Guitar Amp 4. (This will be the second #55 you encounter, and will have a small dot to the right of the
numeral.) In a moment, the “55.” will start flashing.
13. Press the {B} button. If its red LED is on, press it again. Press {<} until the red numbers are flashing. Dial in #51, Large
Room Rev. In a moment, the “51.” will begin to flash.
14. Press {>} once. Set Mix= to 43.
15. To save the set-up, press {CONFIG}. Press {WRITE}. Use the data entry knob to select a location in the DP/2’s
memory. Press {WRITE} again.
16. Name your set-up by using the {>} and {<} buttons to underline each character, and the data entry knob to dial in the
character you want. When you’re done, press {WRITE} again.
Tip: To customize either of the effects, press {EDIT}, the appropriate letter and {>} or {<} to select its
parameters; use the data entry knob to edit them. You can change the “Volume=“ parameter in an effect to adjust
how much of it you’ll hear. You can also press the {A} or {B} buttons to turn off either of the processors (its red
LED will flash). Press again to turn it back on (the red light will go out). Footswitches can accomplish the same
thing—see the “Using Foot Switches” Quick-Start for details.