Specifications

Part # 9310 0188 01 - A Model # MM-87
Drum Kit—Gated Room Sound

Large Room Rev
#51
0276
E
EF
02765 762765
EF

EQ-Compressor
#86.
~


This Quick-Start describes how to get a very popular big rock/pop drum sound.
1. Turn the DP/2 inputs and outputs knobs down all the way (counter-clockwise).
2. Connect a mono effect send from your mixer to the DP/2’s rear-panel Input 1 jack. Use this send for mono drum sounds
such as the snare and/or bass drum.
3. Connect the DP/2’s Outputs 1 and 2 to two effect returns on your mixer. If you’d prefer to use only one mixer return, use
Output 1 and leave output 2 unplugged.
4. While sending some drum sounds into the DP/2, turn the input 1 knob clockwise until the red peak LEDs just above it is
flashing occasionally.
5. Turn the outputs knob up until your mixer is receiving the proper level from the DP/2.
6. Press the {SYSTEM/MIDI} button. Press the {>} button until the large red number reads “46.” Use the data entry knob to
dial in “Set All 1U Pset Mixes To Wet=Yes.”
7. Press the {EDIT} button, and then the {CONFIG} button.
8. Press the {<} button until the large red numbers read “00.” Dial in “1 Source Config.”
9. Press {>} once. Use the data entry knob to set the AB Input Select to “mono.”
10. Press {>} once. Set the AB Unit Routing to “serial.”
11. Press {>} until “(b)ypass (k)ill” is displayed, and the letter following “A=“ is flashing. Dial in the letter “b” (if “b” isn’t already
displayed). Press {>} again to do the same for Unit B.
12. Press the {A} button. If its red LED is flashing, press it again. Press {<} until the red numbers are flashing. Dial in #51,
Large Room Rev—the “51” will start flashing.
13. Press {>} until “Room Decay” is displayed. Dial in a value of 1.30.
14. Press the {B} button. If its red LED is flashing, press it again. Press {<} until the red numbers are flashing. Dial in #86.,
EQ-Compressor. (This will be the second #86 you encounter, and will have a small dot to the right of the numeral.) In a
moment, the “86” will begin to flash.
15. Use the {>} button and the data entry knob to set Compressor Gain to +15, Noise Gate Off Below to -31, Noise Gate On
Above to -25 and Gate Release Time to 40ms.
16. To save the set-up, press {CONFIG}. Press {WRITE}. Use the data entry knob to select a location in the DP/2’s
memory. Press {WRITE} again.
17. Name your set-up by using the {>} and {<} buttons to underline each character, and the data entry knob to dial in the
character you want. When you’re done, press {WRITE} again.