Specifications

Part # 9310 0188 01 - A Model # MM-87
Darth Meets Alvin

Pitch Shift 2U
Config Preset 60
0276
E
EF
02765 762765
EF



This Quick-Start provides an amusing audio transmogrifying effect.
1. Turn the DP/2 inputs and outputs knobs down all the way (counter-clockwise).
2. Connect a CV foot pedal (such as ENSONIQ’s CVP-1) to the rear-panel CV•Pedal jack.
3. Plug a microphone’s effect send from your mixer into the DP/2’s rear-panel Input 1 jack.
4. Connect cables from the DP/2’s back-panel Output 1 and 2 jacks to two inputs on your mixer or stereo amplifier. If you’re
going to a single-input mixer or amp, use only Output 1.
5. While speaking, turn the input 1 knob up until the red peak LED above it flashes occasionally.
6. Turn the outputs knob up until your mixer (or amp) is receiving the proper level from the DP/2.
7. Set your mixer so that you’re only hearing the output of the DP/2, and none of the original “dry” microphone signal.
8. Press the {SELECT} button, and then the {CONFIG} button. Use the data entry knob to dial in #60, Pitch Shift 2U. If the
red LEDs in the {A} or {B} buttons light up, press {CONFIG} again.
9. Press {SELECT} again.
10. Press the {EDIT} button.
11. Press {>} once. Use the data entry knob to set the AB Input Select to “mono.”
12. Press {>} until “(b)ypass (k)ill” is displayed, and the letter following “A=“ is flashing. Dial in the letter “b” (if “b” isn’t already
displayed). Press {>} again to do the same for Unit B.
13. Press the {A} button. Press {<} until the red numbers are flashing.
14. Press the {>} button four times so that the “-07” is flashing. Dial in a value of -02.
15. Press {>} four times and use the data entry knob to set PitchShifter Vc2 Fine to +02.
16. Using the {>} button and the data entry knob, set Mod1 Src to Cntrl-6 DP4 Analog CV In, Mod1 Destination Parameter
to 03, Mod1 Param Range to Min=30% and Max=99%. Set Mod2 Src to Cntrl-6 DP4 Analog CV In, Mod2 Destination
Parameter to 07, Mod2 Param Range to Min=30% and Max=99%.
17. To save the set-up, press {CONFIG}. Press {WRITE}. Use the data entry knob to select a location in the DP/2’s
memory. Press {WRITE} again.
18. Name your set-up by using the {>} and {<} buttons to underline each character, and the data entry knob to dial in the
character you want. When you’re done, press {WRITE} again.
Note: Speak into your microphone with the pedal all the way back to sound like a certain famous promulgator of
The Dark Side. Push it forward—you’re transformed into a chipmunk!